![]() Note the data in this folder will be permanently deleted, so make sure any required data is stored elsewhere. If necessary, you can use the command below to remove the home folder for the pi user at the same time. This command will delete the pi user but will leave the home/pi folder. To delete the pi user, type the following: Work is being done to reduce the dependency on the pi user. If you are unsure whether you will be affected by this, then leave the pi user in place. Please note, though, that with the current Raspbian distribution, there are some aspects that require the pi user to be present. Once you have confirmed that the new account is working, you can delete the pi user. If it runs successfully, then you can be sure that the new account is in the sudo group. The visudo command can only be run by an account with sudo privileges. Check your permissions are in place (i.e. Log out and log back with the new account details. You now need to set a password for the new user: This adds a new user called fred, creates a home folder, and adds the user to the sudo group. To add a new user with the same permissions as the pi user: All Raspberry Pis come with the default username pi, so changing this will immediately make your Raspberry Pi more secure. ![]() You can, of course, make your Raspberry Pi even more secure by also changing your username. Simply type in your new password and confirm it. ![]() In fact, all raspi-config does is start up the command line passwd application, which you can do from the command line. Select option 2, and follow the instructions to change the password. This can be done via the raspi-config application, or from the command line. So the first thing to do is change the password. So, if you can get access to a Raspberry Pi, and these settings have not been changed, you have root access to that Raspberry Pi. The default username and password is used for every single Raspberry Pi running Raspbian. Is there any way to confirm if I have successfully performed the changes Is there any command I can perform after performing these steps to see if I have done it the right way? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |